1966 Ford Fairlane Parts: A System-by-System Restoration Guide

The 1966 Ford Fairlane is a classic that blends clean mid-size styling with real muscle car credibility, especially in the GT and GTA trims. With its crisp lines and a wide range of engine options, the Fairlane has earned a loyal following among restorers who appreciate a car that's a little less common than the usual muscle crowd. Whether you found a solid driver or a project that needs everything, restoring one of these cars is a rewarding job. The key is to work through it in an organized way, tackling one system at a time instead of chasing problems as they come.

Here's how the major systems break down on a 1966 Fairlane and what you'll want to inspect or replace as you go.

Engine and Cooling

The 1966 Fairlane offered everything from the economical inline-six to small block V8s and the big block 390. Whatever sits under your hood, decades of heat cycles wear out gaskets, seals, hoses, and belts. Service the cooling system early in the project. A tired radiator, a worn water pump, or cracked hoses can overheat a freshly built engine fast, and that's the last thing you want after an expensive rebuild. Replace the thermostat, clamps, and any questionable hoses while everything is apart.

Brakes and Hydraulics

Many 1966 Fairlanes came with four-wheel drum brakes, though front discs were available on some cars. Either way, old hydraulic systems should never be trusted on faith. Rebuild or replace the master cylinder, wheel cylinders or calipers, brake hoses, and hardware. A soft pedal or a car that pulls to one side points to trouble you don't want to discover on the road. Fresh brake components are some of the most important parts you'll buy, and you can browse our full parts catalog to match the correct setup for your car.

Suspension and Steering

The Fairlane's ride and handling depend on bushings, ball joints, tie rod ends, and springs that have likely seen better days. Worn front-end parts make the car wander and clunk over bumps, and they wear out tires fast. Replace the control arm bushings, idler arm, and any loose steering components, then get a proper alignment once everything is tight. Fresh shocks and springs will transform how the car drives and bring back that solid, planted feel.

Fuel System

If the car has been sitting, assume the fuel system needs attention. Old gas turns to varnish and gums up everything it touches. Replace the fuel lines, filter, and pump, and rebuild or replace the carburetor. A clean fuel system is the difference between a car that fires right up and one that fights you every time you turn the key.

Electrical

Decades of heat and vibration are hard on wiring, switches, and connections. Brittle insulation, corroded grounds, and worn switches cause the kind of gremlins that drive restorers crazy. Inspect the harness, clean up your grounds, and replace any cracked wiring or tired switches. Updating the ignition system at the same time makes the car far more dependable.

Interior, Seals, and Trim

Once the mechanicals are sorted, the finishing touches bring the car to life. Replace cracked weatherstripping around the doors and windows to keep out water, wind, and noise. Worn carpet, split seat foam, and faded trim are all part of a full restoration, and fresh seals make the whole car feel solid and quiet again.

At Classic Parts Pro, we know what it takes to bring a 1966 Fairlane back to its glory days, because we've turned the same wrenches and fought the same rusty bolts. You'll find fast shipping, easy returns, and real technical support from people who actually know these cars. For more model-specific help, check out our other restoration guides, or head back to our homepage to start your build with confidence.

Want me to keep the rotation going with a Chevrolet next?